Garage Floor Coating Removal in Antioch
Epoxy Floors Craft Antioch covers removal and recoat of peeling or worn garage floor coatings in Antioch — reading why the old paint or epoxy failed, taking it down to sound concrete and changing the prep so the next one does not follow it.
Bookings aren't open yet. Leave your name and number; your message is recorded, and you'll get one message when a local installer is available.
Illustration
Reading the failure before ordering the fix
| Symptom | Likely cause | How it is prevented next time |
|---|---|---|
| Peeling in sheets | Weak or no mechanical prep, or moisture vapor pushing from below | Diamond grinding and a moisture test |
| Lifting where tires sit | Hot-tire pickup on a thin or poorly adhered coat | Ground slab, a system rated for it |
| Yellow or amber tint | Epoxy top coat in sunlight | UV-stable top coat such as aliphatic polyaspartic |
| Bubbles and pinholes | Air leaving the slab as it warmed | Seal coat, correct temperature window |
| Sticky or soft patches | Wrong mix ratio or cold, damp cure | Cure window and mix control per data sheet |
| Chipping at the door | Impact and a thin film | Thicker build, coved edge at the threshold |
| Cracks reflecting through | A crack that was painted over, not repaired | Cut, fill and grind the crack flush |
Hot-tire pickup is mostly a prep and product problem; peeling in sheets usually points to the slab.
The test grind and the scrape test
Before anything is priced, a small area is ground and the edge of a bad spot is scraped with a putty knife. If the coating comes up in a ribbon, it never gripped. If it resists, it can often be ground and recoated rather than removed. This is the cheapest decision in the whole job, and it avoids paying removal prices for a floor that did not need it.
How an old coating comes off
- Diamond grinding is the standard for thin paints and epoxies on residential slabs, run with a dust-shrouded machine and vacuum.
- Shot blasting peens the surface and suits larger floors or thick coatings.
- Scarifying and mechanical scraping deal with thick build-ups or tile glue.
- Chemical strippers work only on small patches.
Removal leaves the slab rougher than a first-time coating would, which is why it adds about $2–$6 per square foot to a new system in Antioch in 2026. For a 420 square foot garage with flake epoxy, that is roughly $3,360–$6,300 in total.
Older garages: paint and mastic
About 23.5% of Antioch's housing predates 1970 and 59.1% was built between 1970 and 1999, so many garages fall in the range where the question matters.
What a recoat should do differently
A recoat repeats the failure unless the cause is addressed. Take the symptom table to every bid and ask what changes: grinding instead of etching, a moisture test and a primer where needed, cracks cut and filled, and a top coat that matches the sun and tire exposure of the garage. Ask for the film thickness in mils and the written warranty terms; warranty terms are set by the installer and by the coating manufacturer, so ask what is covered (peeling, hot-tire pickup, UV yellowing), for how long, and whether the prep is part of it.
Garage Floor Coating Removal — common questions
How much does it cost to remove an old garage floor coating in Antioch?
About $2–$6 per square foot in 2026, added to the new system. A 2-car garage of 420 square feet with flake epoxy lands near $3,360–$6,300 including removal. The figure is a market estimate, not a quote.
Can a new coating go over the old one?
Sometimes. A sound, well-adhered coating can be ground and recoated; peeling, chalky or glossy-over-paint surfaces are removed first. A small test grind shows which one the floor is.
Garage Floor Coating Removal: check availability and price range
Bookings aren't open yet — a typical Antioch range in about 30 seconds.